Questions & Answers for: Scytek alarm system

...alarm I took my car to get a diagnostic run on it. There was one message that had to be reset in my computer system on the car. After receiving my car back from the shop, my car would no longer ...

...alarm system and i didnt get the manuanl for this alarm system , the code for the this alarm system? can you please help with this solution? my name is joey? thank you guys Is it the Long E 6500 Two ...

...alarm, or just reset it. Claudia if it it receiving the signal to the remotes making them beep completely reset the system and re-program the remotes. i had the same problem and this worked for me! ...

...system is Armed (locked) the Alarm goes off when using the remote start.. If I use the remote start with the system disarmed(unlocked) then it stars fine with no alarm. This seems reversed from what ...

...alarm is triggerd alot, door or hood open everytime. spray WD-40 on the hood pin switch and the door latch, not unless your car is a ford, it could be the R.A.P system shutting down, diodes may need ...

where can I get a manual for a galaxy 5000rs http://www.scytek.net/ ...then go to the 'downloads' section ;-)

...will probable cook your car wiring loom and it will catch on fire ,take fuse out and take it too an alarm fitter to get it fixed cheaper than a new ...

...remote start turn it on then shut off remote start and disable the alarm should reboot the alarm system. if not unplug the battery for about a minute it will reset the alarms disable car start ...

...alarm system? ...

after setting remote start ,if d door is opened or alarm triggered it would not remote start again unless you redo the setup of remote start . eg. with engine running put park brake on take foot off ...