Questions & Answers for: Fisher and Paykel air in pipes

...overflow. We have checked the drain pump to make sure it is clean. We have also checked the air hose to the water level sensor for any cracks or holes and that appears ok. Could the problem

...drum this has tube which leads to the pressure switch Make sure there is no congealed soap in the Air Bell as it is ...

...getting dry you probably have lots of lint accummulated in the vent pipe which is stopping the wet air from escaping to the out-of-doors. To solve this pull out the dryer, unplug it and then ...

My dryer is having issues venting out air from drying the clothes. The technican says I need a 30 foot vent tube to the outside. The length my dryer vents to is about 45 feet what can I do . What ...

...clean but no difference. The clear pressure tube to the motor controller is dirty or blocked. Blow air down the pipe to dislodge any blockage & refit the

...If no water in the machine.The clear pressure tube to the motor controller is blocked. Blow air down the pipe to dislodge any blockage & refit the

are two good ideas for clearing the blockage. The best way off clearing the tube is with compressed air, often difficult to get in your kitchen, but don't despair, there could be two solutions in your

...the wash setting on, so water is then pumped out of the machine The pressure switch usually has air in the feed pipe which sometimes gets water into it which then fails to notify the system when ...

...air dampener as shown below - kind of like a shock absorber on your car but in this case, the backlash of pressure is softened or eliminated by it or something similar. Basically what's happening is ...

...moisture in side the drum fisher and paykey ed56 Moister in the dryer: This means that the moist air is not escaping correctly and that is why it is taking so long to dry your clothes - if they