...air induction chain saw wont start,keeps flooding 55cc air induction chain saw wont start,keeps flooding what do you mean by flooding? if it is overflowing? try to remove the 4 screw underneath the ...
air filter back plate, remove the wire throttle rod, now remove the two cross head screws from the carb back plate into the crankcase, finaly remove the the two 7mm studs securing the carb, remove the
...air fiter back plate foot, remove the pump cover on the carb, this is the alloy cover held with a single screw, clean/replace the filter screen under the diaphram, if the pump diaphram looks aged ...
Question about ChainSaw 18 in Bar 32 HP Model 350
...the air filter, if fitted check the spark arrestor in the muffler is not blocked, check the fuel hose for splits or leaks, check the rubber induction tube between the cylinder and the carb for
...idle is normally an air leak, so yes it could be crank seal leaking, or the induction tube cracked, or the impulse tube from the crankcase to the carb cracked, or the cylinder base gasket blown
Question about ChainSaw 18 in Bar 32 HP Model 350
...air filter ok ,fuel line not leaking, Conected to the rubber induction boot is the impulse hose, it is a short curled pipe, make sure this has not split and is conected to the two nipples on the carb ...
Question about ChainSaw 18 in Bar 32 HP Model 350
...air somewhere other than the carb it will lean the mixture and increase the idle speed, you are looking for a leaking gasget or crankshaft seal, this is no so easy without proper tools to do a ...
Question about 36 41 50 51 55 136 141 154 254 257 261 262 Oil Cap Aftermarket
...problem? Very unlikley to be an air lock, more likley to be a massive air leak, check the rubber induction tbe behind the carb mount it may have split, if not then a possible blown crank
Question about 36 41 50 51 55 136 141 154 254 257 261 262 Oil Cap Aftermarket
...is off The Carburetor or the AIS(Air Induction System) maybe the culprit or if they are fine, then the engine valves are needed to be replaced. Generally backfire occurs due to faulty engine
Question about 36 41 50 51 55 136 141 154 254 257 261 262 Oil Cap Aftermarket
...air induction holes, sharpened blades, too Could it be loose belt/bearing issue? Hi Alan: You're the best person to answer those questions. With the motor OFF, mower engage OFF, and gloves on, try to ...
Usually answered in minutes!
529 Questions
514 Questions
473 Questions
353 Questions
122 Questions
