Questions & Answers for: Honda XR 600 R air filter

Question about 1995 XR 600 R

1 Answer

...air filter, cleaned carb and tried new rev box. Still has problem, have raised idle to compensate. Any suggestions, i am thinking stator. Carb jets may still be dirty or improperly sized. The Cam ...

Ad

...the drain plug is on the left side it is also a good idea to change the air filter, but if its not too old you can soak it in gas, when the filter gets old it falls apart. i have an 85

Ad

...air filter it cuts out at top end unless you take air boot off no. 2carb then it rev up or put old air filter on & leave side cover off it will rev up what wrong. when you put on a new air filter ...

Question about 1985 XR 600 R

2 Answers

...air filter so it is not letting particles through. It doesn't take much to clog a jet. Here is a link to a rebuild of an XL600R that goes through many steps and lots of problem solving to get a bike ...

filter , Air filter already clean. I backed off compression release all the way on the head, It just seames to kick over way too easy for NOT using the compression release. I used my spare compression

Question about 1995 XR 600 R

1 Answer

...air filter box. It's for ventilation of the crankcase, much like the PCV (Positive Crankcase Ventilation) in cars. As the bike runs, the crankcase gets hot enough to vaporize some of the oil. And ...

...replacing the plug, cleaning the air filter and going from their. Also some models had a problem with the choke butterfly breaking and being sucked into the inlet, another good thing to quickly

Question about 1996 XR 600 R

1 Answer

air filter in order to get the proper vacuum to "SUCK" the fuel out of the float bowl and create the proper venturi effect. Improper mounting and sealing of the airbox will create a small lean effect.

...filter clogged. 3. Fuel line pinched or kinked. 4. Vacuum line from the petcock to intake manifold cracked. 5. Float needle and seat sticking. 6. Float level too low. 7. Carburetor bowl vent line ...

...air filter and clean as necessary. Make sure choke, if fitted, is working properly. Check ignition switch for water flush with WD 40 or similar then spray in silicon oil. Check engine kill switch is ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...