Questions & Answers for: Harley Davidson XLH Sportster 883 Hugger air filter

air filter...if you have a lot of mist it soaks the air filter and drips down then gets blown usually in my case on my leg. How can you fix this? It could be the umbrella seals in your heads are tired

...air filter. Run it until it dies and then look into the carb and "milk" the throttle a couple of times. You should see a jet of fuel from the accelerator pump squirt into the carb throat. If you do, ...

...air intake filter. I was told I have too much oil in my resevior, but I am not registering oil on my dip stick. anyone know what the problem is? The only way for the oil to get to the intake is ...

...air filter and it was soaked with gas. Is the choke stuck or broke?? No id say the float is or was stuck tap bowl or remove & clean shut off needle ,,, clean air filter or if not washable replace ...

...air filter and routed to the front of the bike. I am assuming it goes to the VOES switch but I can not locate it. can anyone tell me where the switch is located or what this hose might go to? Usually ...

...air filter and spark plugs. Any other ideas or suggestions? Change what you said and check to see if both plugs are getting spark, maybe you have a bad coil. also get a carb rebuild kit. The ...

filter. 9. Fuel tank vent system plugged or carburetor vent line closed off. 10. Carburetor controls misadjusted. 11. Damaged carburetor. 12. Loose or dirty ignition module connector at crankcase. 13.

...bike started making tapping noise, followed by oil blowing out the breather, then it died. smoke comes out the tail pipe, air filter is full of oil sounds like it could be a ring problem ...

...air filter is saturated with oil just changed the oil, rode three hours, smoke coming out t5ailpipe, tapping sound kinda sounds like you broke a ring or crank case vent plugged Had that happen to a ...

...air filter and then eventually gets blown all over the side of the bike. The best way to vent it, is to route a hose from the breather system down to the frame between the engine and trans, run it ...