air duct assembly. 3. Disconnect A/T fluid cooler hoses. (Install blind plug to avoid leakage of A/T fluid) 4. Disconnect radiator upper and lower hoses from radiator. CAUTION: Do not allow coolant to
...air duct. Note the locations and remove the vacuum hoses. Disconnect the heater hoses from the engine. If equipped, disconnect the A/T cooler hoses from the transaxle. Disconnect the fuel hoses from ...
...cooler if the thermostat is stuck open. Please see my tip at http://www.fixya.com/cars/r6235876-no_heat_fan_blowing_cold_air to troubleshoot the heater. In particular, I would start by checking the ...
...air lines needed to connect the turbo; then you will need a new fuel injection pump - the old one is too small for the amount of fuel required in the turbo motor; then you will need to completely ...
Usually answered in minutes!
1,587 Questions
1,450 Questions
1,309 Questions
1,122 Questions
1,306 Questions
