Questions & Answers for: Chevrolet HHR air box

...air intake hose to the filter box. It is at the left rear of the box as you look at it from the front of the car. 2. Disconnect the MAP sensor wiring. 3. Disconnect the coupling to the engine intake. ...

...air intake hose to the filter box. It is at the left rear of the box as you look at it from the front of the car. 2. Disconnect the MAP sensor wiring. 3. Disconnect the coupling to the engine intake. ...

...air intake hose to the filter box. It is at the left rear of the box as you look at it from the front of the car. 2. Disconnect the MAP sensor wiring. 3. Disconnect the coupling to the engine intake. ...

...air filter for 2008 HHR Open the glove box on the right side of the dash. There are tabs on each side that must be pushed inward to release the glove box, and let it open completely. You may need to ...

...air intake (hard plastic hose going into the "box") You most likely have, or have had, water in your passenger side floor board area as well. The resistor is in direct line with one of the water leak ...

...air filter It's behind the glove box. They're are 2 clips one on each side of the glove box you release those and the glovebox door drops down farther and you will see the cover for your cabin air ...

The MAF isn't doing it's job anymore of telling the ECM that there's more fuel needed to the engine. Replace it, which is mounted near the air cleaner box, and the car should run just fine after that

...the hoses that connect it to air box or the throttle body. or rarely a bad computer. most likely dirty or faulty mass air flow sensor. the maf can be cleaned with spray cleaner but be gentle with

air filter box cover and inspect the filter ---> is the air filter clean? If no, replace the air filter If yes, remove the engine cover - 3. Find the fuel rail located toward the back of the engine

...air and ac snowflake light not working the climate control module mat have died have an ac specialist shop check the ac system for leaks and if ok , replace the module You may need to check vacuum ...