Questions & Answers for: air bound cooling system

...air bound? Water pump not circulating coolant? Defective radiator cap? Occasional overheating, if not related to low fluid or other problems, is usually caused by a sticking thermostat. Thanks Good ...

...air bound or not circulate. Mechanic let it idle for three hours without incident. I drove 1/2 hour home and it is overheateing again. Do I really have to take the whole nose off to replace the ...

...air bound ( there is a air bubble in your cooling system,or your water pump isn't turning.Bleed the cooling system by jacking car upso the antifreeze fill area is the highest point and run the ...

...hot. Could it be the radiator or have the head gaskets been blown. first check to make sure the cooling system is not air bound,takes a while to bleed off the air,try this and get back to me Thanks ...

...air bound heater core, defective heat blend door control servo. Start with coolant level, if o.k. check hoses feeding heater core. If the lines are both hot suspect blend door servo/control unit. If ...

...air bound,how do you bleed it? Just top off the radiator and overflow resevoir. Drive the car until it reaches temperature. Shut down and allow to cool. Check level and top off again if necessary. ...

...air bound, how can I bleed it out? Look for bleeder valves somewhere on the top of the cooling system. If you see any use them to remove trapped air. Start the engine and slowly turn the screw to ...

air-bound, need to purge system, Fill radiator, run engine for about 4 minutes at idle, turn off let cool down for about 5 min then being careful recheck coolant in radiator, top off fluid then repeat

...air well it is 20yrs old so things are bound to go wrong ,the front demistor is no doubt a operating flap not working also the spongrubber seal could have perished away by now as well ,if heater isnt ...

...1 gal -check operation of thermostat --water pump and for air bound Check if there is air trapped in the cooling system after the radiator flush, which can prevent the system from being properly ...