...air out of the lines, and retry. Check for fluid leaks. the truck is new enough that it will have a hydraulic clutch system, it is either out of fluid, if thats the case there is a reason it is out, ...
...bell housing. If there is any air in the lines , the slave cylinder will not move far enough to disengage the clutch. The lines can be bled of air bubbles much the same way a brake line can be bled. ...
...air out of line or any pressure. please help. here is a bleeder at the lower clutch cylinder near or on clutch cover (bell housing) that should have a nipple similiar too the ones on brake system ...
...air tools would be a big help and long with a pry bar 1. mark and remove the drive shaft. ( marked in the rear by the ujoint ) 2. remove the bolt from the trans mount 3 support the trans and remove ...
air - pull the driveshaft, the linkage and any sensor wiring, pull, drain and cap the cooling fluid lines and then just start unbolting everything around the bell-housing. I forget if mine had a cross
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions