Loose agitator Maytag LAT2600AAE Seems like a lot of people are having problems with the loose agitators. Same for me. I can completely remove the agitator and I don't see any hole (s) for a set screw
loose agitator i have a whirlpool ultimate care II washing machine. the agitator is loose. how can i tighten it up? the model # is: LSN1000JQO & the ser # is: CK2515891. any help would be appreciated!
Question about LSQ9600L Top Load Washer
...loose. You need to replace the agitator dogs inside the clothes mover (agitator). take of the top then the cover, remove th bolt and take the top half off. you should see four "dogs" that need to be ...
loose agitator bolt, or the agitator dogs wearing out. The following link explains: http://www.fixya.com/support/r823955-replacing_agitator_dogs The upper portion of the agitator is called the "auger"
...loose agitator bolt that requires tightening. If its only the auger (upper portion of the agitator), you have worn agitator dogs that need to be replaced. The following link explains how to replace ...
Question about Ultimate Care II LSQ9549L Top Load Washer
agitator is coming loose. how do i tighten it The top of the agitator comes aparts and reviels a bolt. Push the agitator back down and tighten the bolt snug.
...from the agitator on my top load washer comes loose. When this happens, it will not agitate or spin. No matter how hard I tighten it down, it always comes loose. get a new cap or try some sort of ...
agitator seems loose on my Maytag top loading machine.. model LAT9206BAE it started this after one of my kids overloaded the machine.. works fine but makes a loud clanging noise while washing.. almost
Question about Ultimate Care II LSQ9549L Top Load Washer
...loose agitator (some agitators can betightened from the top, check for tightness)If you can't tighten the agitator from the top, turn the machine over ( you will probably need to disconect ...
Question about Ultimate Care II LSQ9549L Top Load Washer
...agitator bolt comes loose - does it need loctite? I was asked by a friend to have a look at her Simpson Encore 605. The agitator wasn't agitating on the wash cycle. It turned out the bolt ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions