Questions & Answers for: agitator loose

Loose agitator Maytag LAT2600AAE Seems like a lot of people are having problems with the loose agitators. Same for me. I can completely remove the agitator and I don't see any hole (s) for a set screw

Agitator loose Agitator seems to be loose. How can I get dismantle the agitator to check it and repair it? I took the agitator cap off, but there is an apparently unremoveable plastic separator on top

...loose. You need to replace the agitator dogs inside the clothes mover (agitator). take of the top then the cover, remove th bolt and take the top half off. you should see four "dogs" that need to be ...

...spins again when you release pressure. Remove the top cap on the agitator and see if the bolt has come loose. If it is not there, the agitator will come loose from the gear case shaft and free

...part way. Pull up on the agitator by both sides of the rim, then finish removing the bolt after the device is loose. (Keeps you from smacking your face when the agitator comes loose.) Hope this

...agitator spline to transmission shaft had come loose which allowed the plastic spline inside the agitator to be wallowed out. The replacement spline came with a re-designed bolt and instructions to ...

agitator loose agitator came loose. sounds like a nut rattling around inside it. how do you disassemble the agitator to retreive the nut and rebolt it? lift out the softener cup located on top of the ...

...loose agitator (some agitators can betightened from the top, check for tightness)If you can't tighten the agitator from the top, turn the machine over ( you will probably need to disconect ...

...agitator bolt comes loose - does it need loctite? I was asked by a friend to have a look at her Simpson Encore 605. The agitator wasn't agitating on the wash cycle. It turned out the bolt ...

LOOSE AGITATOR AND TUB HOW DO I KNOW IF AGITATOR AND TUB ARE LOOSE OR IS THAT THE WAY THEY ARE SUPPOSED TO OPERATE? The tub hangs on 4 suspension rods the agitator is pressed on to the agitator ...