...starts the cycle water start to run or drain depending on cycle but it will not spin or begin otherwise. This is a frigidaire affinity, restarts cycle after 3 minutes pass on digital display. Please ...
...affinity frontload washer stuck on normal cycle flashes pau. when u press any button or turn knob it flashes err. only have start/pause button and cancel button no stop button. tried to hold them ...
Question about Affinity ATF7000E Front Load Washer
...Washer, 417.44082400, will not spin fast during Permanent Press Cycle. The clothes are dripping wet. It starts to spin and stops, starts to spin and stops, etc. Normal cycle runs fine. Rinse and Spin ...
Question about Affinity ATF7000E Front Load Washer
...affinity washer starts the cylce and after 2 minutes into the cycle it stops and says pau. I have tried it on several cycles and always the same thing. The PAU is a power interruption. Look for ...
Question about Affinity ATF7000E Front Load Washer
washer that has been pausing the wash cycle on it's own. I will have to press the start/pause button during the cycle to restart. This happens several times during a wash cycle. How can I fix this
Question about Affinity ATF7000E Front Load Washer
...Affinity washer stopped working. When i start the cycle it makes a loud humming noise, but no water goes in, and it starts spinning for a few minutes, then the time goes from 1hr, to 3 m It's ...
Question about Affinity ATF7000E Front Load Washer
...Affinity is brand new. Just did our first load of laundry and mid cycle it stopped and the PAU is lighting up intermittent with the time left. I have tried everything I can think of and it will not ...
Question about Affinity ATF7000E Front Load Washer
...Affinity washer stopped working in middle of cycle and shows E41 code. I tried to restart it but I don't hear the door switch clicking as I usually do, and it will not start the cycle. There ...
Question about Affinity ATF7000E Front Load Washer
...Affinity washer, model# ATF7000E, is buzzing and will not cycle. Some possible causes of this could be: -Your washer is overloaded with clothes. Try taking some clothes out and restarting. -There ...
Question about Affinity ATF7000E Front Load Washer
...Affinity washer stopped working in middle of cycle and shows PAU code. The washer shut down in the midst of a quick (25 minute) wash cycle with 14 minutes left. I turned off the power strip for a ...
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions