clutch adjustment and fluid recomendation. how do i adjust the clutch once the derby cover is off? is the fluid up high enough to where its going to spill out? if so what kind do i put back in? Find ...
Question about 2004 XL 1200 C Sportster Custom
how to adjust primary chain and clutch on 04 1200c thanks First, let's adjust the primary chain first. Remove the upper inspection hole cover. Stick your finger in the hole, find the chain, and raise ...
took stock cable out of primary. put new cable in and the clutch wont engage First, are you sure you got the correct cable. If so, let's try adjusting it. First find the cable adjuster, loosen the ...
...and a wrench on the nut you have just welded on. Makes it a lot simpler. You can also see "clutch adjustment by the book" in this same forum found-- HERE.. Hope this helps Fix Ya
how to adjust a clutch cable on a 2006 1200 sportster You need to adjust the entire clutch release mechanism. Find the clutch cable adjuster in the cable. It should be covered with a rubber bellows ...
Question about 2006 XL 1200 C Sportster Custom
...on 2000 XLH, now it is impossible to engage Adjusted the clutch on 2000 XLH as follows; turned adjustment screw in ccw until seated, then out cw 1/4 turn. fired up and shifted into 1st, nice and ...
2004 1200c clutch adjustments Hi Anonymous, spray some silicone or brake kleen at the top inside of the rubber boot covering cable adjuster and slide boot off the adjuster. Back off jam nut and screw ...
Question about 2000 XL 1200 C Sportster Custom
my clutch so how do i properly adjust the clutch on 07 h.d. xl 1200 sporty-youttube Slide the rubber cover off the cable adjuster. Then holding cable adjuster with 1/2 inch wrench, loosen the jam nut ...
Question about 2003 XL 1200 C Sportster Custom
how do i adjust my clutch on my 2003 1200c sportster Slide the rubber cover off the cable adjuster. Then holding cable adjuster with one half inch wrench, loosen the jam nut using a 9/16 inch wrench ...
Question about 2003 XL 1200 C Sportster Custom
...from the clutch lever, then turn the clutch cable adjuster to obtain the clearance gap c. When the adjustment is correct, tighten the clutch in-line cable locknut and slide the rubber boot over the ...
Usually answered in minutes!
586 Questions
351 Questions
242 Questions
159 Questions
145 Questions