Questions & Answers for: Dodge Neon adjusting electric steering

...steering pivot bracket. Adjust the tension as follows: Belt tension with no belt replacement: A. Using the Belt Tension Gauge Special Tool Kit C-4162, adjust the belt tension to 100 lb. B. Tighten in ...

a short in the steering column.You should have an auto electric shop have a look. you need a new turn signal switch. since the brights toggle is in the same cluster it shorted and turned on the lights

Replacing the highbeam switch on a 2000 Neon - is it a big job? Went to dim my lights and noticed a funny smell (electrical - burning). The lights dimmed but they won't switch back to high beam. How ...

I had to rev it to start and it would often die at intersections Got a noisy power steering and I had to rev it to start and it would often die at intersections when I didn't keep the RPMs up.I don't ...

I have a 2000 Dodge neon, and I need a Passenger side front inner tie rod. How do I know if mine is a firm feel steering or non firm feel, because those are the two different types of tie rods I can ...

Check engine light according to advance auto is the result of a power steering presure censor that has gone bad. Is this a major expense and what is involved to get it fixed? Thanks! this isn`t a ...

...steering load into output voltage, and emits the voltage signal to the Powertrain Control Module (PCM). The PCM controls the electric throttle control actuator and adjusts the throttle valve opening ...

what is a clock-spring ribbon contact Its part of the device in the steering column that allows electrical parts to make contact while the steering wheel is being  turned.Its under the steering ...

adjusting screws on boxes that will take out excessive play in the steering. However if it still follows the road contours dips etc I suspect that the alignment has not been done to specs as incorrect

serpiten belt is lose how do I tighten my servinen belt in a 1996 dodge neon Have to loosen pivot bolt at bottom of power steering, plus top adjustment and use 1/2" drive bar in hole supplied in ...