Question about Craftsman LiftMaster Chamberlain Garage Door Opener Wireless Keypad Model 976LM Security+
...1/2 hp door opener intermittingly reverses 3 inches from fully closed...will always go down once button is pushed to stop and then pushed again to close door. No obstructions, sensors are aligned and ...
Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
chamberlain garage door opener not working properly door closes 85 - 90% and then reverses how do we adjust this Turn up the force adjustment or the bottom part of the door could be getting in the way
Question about Craftsman LiftMaster Chamberlain Garage Door Opener Wireless Keypad Model 976LM Security+
...1/2 hp chain drive only opens door ~6" Replaced a 25+ year old Chamberlain 1/2 hp chain drive that died w/ a Craftsman 95320 1/2 hp chain drive. Did not replace rail or chain both of which seem in ...
Question about 1/2-HP Whisper Drive Belt Drive Garage Access System
chamberlain whisper garage door opener 3/4 hp door doesn't close all the way down? DOES IT REVERSE OR STOPS BUT NOT TOUCHING THE FLOOR? IF IT DOESN'T TOUCH THE FLOOR YOU EITHER NEED TO ADJUST THE DOWN
Question about 1/2-HP Whisper Drive Belt Drive Garage Access System
...garage door and now the belt on my Chamberlain Whisper Drive WD822 KL is really tight and the opener is not quiet anymore. The door still closes down perfectly tight against the floor and lifts ...
Question about 1/2-HP Whisper Drive Belt Drive Garage Access System
...chamberlain whisper drive garage door opener. When I open the door and it reaches the top it starts making a loud noise. It's like the motor is still trying to pull the door up but it can't because ...
1/2 hp heavy duty. Any suggestions? Hi swilson.... on the motor you will find adjustment screws. One to adjust the up setting and one the down. Also one for the pressure setting. Usually when the door
Question about Craftsman LiftMaster Chamberlain Garage Door Opener Wireless Keypad Model 976LM Security+
...1/3 HP garage door opener. i need to tighten the chain, can anyone tell me how this is done? The adjustment for the chain is done at the back side of the trolley. A 1/2 inch open end wrench will do ...
Question about 1/2-HP Whisper Drive Belt Garage Door Opener LW3500
...chamberlain garage door opener and it does not stay close. it comes down and rises right away You have to adjust the safety pressure sensor. It is set to too light a pressure. Check your manual for ...
Question about Powerdrive PD422D 1/2 HP Security Plus Screw Drive Garage Door Opener
...1/2 HP 4200 on and old metal door. Change went smoothly and worked fine. Did you leave something in front of the infrared safety sensors? Or is needs resetting for motion of travel. Adjusting travel ...
Usually answered in minutes!
4,713 Questions
76 Questions
33 Questions
36 Questions