adjust the throttle position sensor on my 86 s-10 2.8 two wheel drive? there are three wires going to the TPS one is a ground and one is a 5 volt reference the other is the sensor return you will need
...TPS needs to be adjusted to attain the correct idle. Loosen the screws and rotate it slightly forwards or backwards to get the right idle. The correct way is to use a multi-meter and adjust it based ...
...TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V). Did you adjust it when you installed it? If the signal value is less than ...
...21 I had the same problem. I purchased a TPS on ebay for $14.00 installed it myself, then I adjusted and carb. Then my A/C started working and the truck runs
Usually answered in minutes!
1,473 Questions
904 Questions
790 Questions
747 Questions
686 Questions