...the new part straight and make sure it engages the throttle shaft when replacing it. There is no
When I start the jeep the motor races and will not come down under 1500 rpm until I put it in gear then it drops to normal. With no way to idle the card down mysellf (carburator adjustments)and no ...
...component is faulty. it may be the circuit that is bad or the connector. however, the tps may be adjustable. is one of the screw holes
...TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V). Did you adjust it when you installed it? If the signal value is less than ...
is either your TPS (Throttle possition sensor) or your IAC valve (Idle Air Control). The TPS can be adjusted But the IAC has to be replaced. Both are not that expensive to do..
...TPS (throttle position sensor) is reporting too low a voltage. On some vehicles that lower limit is 0.17 - 0.20 volts (V). Did you adjust it when you installed it? If the signal value is less than ...
...range/ performance problem. Did the TPS have slotted mounting holes? If so it may need to be
Question about 2001 Grand Cherokee
...TPS input to determine current engine operating conditions. In response to engine operating conditions, the PCM will adjust fuel injector pulse width and ignition timing.The PCM needs to identify the ...
Question about 1999 Cherokee
...adjust the TPS for 0.26 volts at minimum throttle opening (idle) worst case: the FSM says it auto calibates if the new TPS errors,. set it to 1/4 volt at idle. reset ECU , all DCTs using scan tool ...
...a circuit high input. Plausible causes would include, TPS not mounted correctly, TPS not properly adjusted, Wiring to the TPS is damaged (ground wire touching another wire), or the TPS sensor is ...
Usually answered in minutes!
3,350 Questions
3,279 Questions
2,899 Questions
2,715 Questions
2,521 Questions