...is 11.5 volts instead of 5 volts. anybody have this problem. This is a 2003 Rendezvous. is the tps adjustable on set screws? is something holding the throttle plate open a bit? throttle bore gummed ...
...they check OK, the Ref volt is there 5 volt, in scanner the angle is registering but no voltage at all on any opening of the throttle please advise replace tps switch and adjust it to factory
...know where this is located or is there a different solution that I am over looking The TPS must be adjusted and set with a voltage meter or a scan
how to adjust idle on a 91 park ave ultra computer controled there is no adjustment, if your having a problem then you have other issues. TPS, MAF, etc..
...cheap these days at any reliable auto parts/Radio Shack store. The setting is 1.5 volts. The TPS is adjustable when the set screws are a little loose. Black wire is negative The other two wires are ...
adjust the TPS voltage on my 1989 buick Lesabre your talking voltage so i will assume you know how to use a voltmeter and how to check tps voltage.with the voltmeter connected if you loosen the sensor
1992 buick regal trouble code 22 at stop light car stalls TPS out of adjustment. test with ohmmeter should rise and fall smoothly while turning. any opens in middle of rotation replace tps
adjust a TPS Sensor on a 1992 Buick 3.3 V6 I have replaced the TPS Sensor on my 1992 Buick Century 3.3 V6 the repair manual says I need to adjust it now how do I do that? Normally you would use a ...
...side wiring is good The either just replaces the fuel not asked for by the tps & ecm then adjusts the injector ...
changed the tps and now have a fast idle Try this: with car running, disconnect the tps wiring harness. After a few seconds, reconnect it. Once it's reconnect, the idle should adjust itself.
Usually answered in minutes!
1,731 Questions
1,603 Questions
1,084 Questions
1,091 Questions
904 Questions