Questions & Answers for: Zebra how i adjust printer

print too light I have adjusted the pressure and Darkness to no avail. Printing acceptable on the left but nearly missing on the right.The printer hadn't been used for several months. Thanks, Steve ...

...adjust the "media rest" position everything appears to work well. However, when I print the next label it reverts back to the same spot, before adjusting the position To be sure we're talking about ...

adjust the gap from top of a label to where it should starts to print? Label definition in printer driver may need adjustment. Try calibrating printer, printer on solid green light, hold down feed key

...6. Any ideas why? Most reasons for this is a slight adjustment problem with page length. You can recalibrate the printer via the menu system, doing it this way will adjust the sensors with new ...

...are in the blind spot. Were would those 10 mm be: left right or split left and right and is this adjustable if so how specifically is this done on the 105SL The extra 10mm would be on the right ...

...half of a ticket, and what it does print is very faded. If the problem is on the right side , try adjusting the head pressure adjustment knob on the top right side. You can adjust with a flat blade ...

...adjust the sensitivity of the printer's sensors. In a printer that has the Thermal Transfer option installed, both media and ribbon sensors are adjusted. In a Direct Thermal printer (no Thermal ...

On a QL420plus, how do i adjust the darkness? andy_arnold: You can adjust the darkness in your software desing or in your epl, zpl commands. You cant adjust it inside printer.

adjust go to printers and faxes, and right click the printer, go to printer properties (or just properties), device options, tools, properties, in the command line you must put the new value. !R_XXXX

...printer starts feeding labels.The POWER indicator will turn off and then switch toGreen while the adjustment is being made.The printer will advance 3-4 labels while performing the adjustment. When ...