...Low and High adjustment screw. At idle turn the screw in or clockwise until the rps starts to decrease. Then start turning it out till you hit max idle rpms. Turn screw back in a quarter to half turn ...
...This should be the correct rpm. If the H and L don't have a screwdriver slot it requires a special tool to adjust high & low. High and low adjusts the richness of the fuel in the
high and low mixture scews I'd start at 1.5 turns CCW from lightly seated. Then tune for performance. It is probably fitted with tamper resistant fittings mandated by the EPA. I contact my local Stihl
...wouldn’t recommend trying to adjust the mixture screws on a carburetor. Definitely bring it to a professional. I fix or try to fix everything and anything. My two exceptions are carbs and ...
...adjust the low idle mixture screw to give you a smooth transition from idle to throttle up. Once this is obtained, you adjust the third or idle speed screw low enough so the chain does not turn at ...
there might not be a high or low adjust as they are ported inside the carb. You might get just the high or just the low adjust needles. I hope this is helpful to you. All the best and good luck. Denis
Question about "Chain Saw - 16" Bar, 3 Hp
...the high screw. Let off the trigger and adjust the low screw. Once the mixture screws are adjusted, you can turn the idle screw to adjust the idle speed. It can take some time getting it all
Question about "Chain Saw - 16" Bar, 3 Hp
...problem - carburetor. If you installed a new carb you have to set it up , with the idle adjustment , and the low and high speed mixture screws. You just do not insert the carb and expect it to
Question about "Chain Saw - 16" Bar, 3 Hp
...adjust high and low speed carb screws on Husqvarna 122C You will need a special tool to adjust the anti tamper screws, do not adjust them to over come some underlying problem i.e dirty fuel, blocked ...
Question about "Chain Saw - 16" Bar, 3 Hp
low a/f set, adjust the high a/f. I usually remove the chain and clamp the saw bar into a vice. That makes it easier and safe. The low adjustment affects the high so anytime you change low you need to
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions