Questions & Answers for: Chevrolet adjust hood

...side hood will not release. The Driver side will release Hood latch on passenger side needs adjusting, Have someone put pressure on side of hood when you are pushing the hood latch release. ...

...hood while you pull the lever should open when opened adjust the cable and grease the catch. It may be frozen/stretched out or broken, try having someone tap the hood at the latch while someone holds ...

...to 60mph). is this normal or can I tighten it up a little You can tighten this up a bit by adjusting the plastic (or rubber) 'bumpers' directly under the hood toward the front of the

...adjust. Very simple to turn which tightens ( or loosens ) the cable. The trick for you is to get the hood to open to make the adjustment. I played with the hood release under the dash until mine ...

on both sides and adjust your hood. Another thing is too roll over a bumpy surface while working the hood lever.If all this fails ecklers corvette sells a hood latch lever to reach the release springs

...Open hood and lube the hood lock and cable going to it. Also could be that your hood stops are adjusted too high. Can reduce the hight by turning them counter

...broken or if its not closing the whole way when you close the hood. if everything looks good try adjusting the hieght of the bumpers which the hood sits on. don't go crazy with adjusting the ...

Hood alignment Hood hits fender on passenger side . Is there's adjustment I can make for this ? try adjusting the hinge at the base of the bonnet. Loosen the bolts slightly and lower the bonnet till ...

...there hand in the middle of the hood, by the latch/front. Then adjust the latch upwards. If the cable is broke then go from the bottom and push the release left or right to release. Follow the

...hitting the hood pops it open, again adjust the latch. If the cable is broken, I suggest you take it someone that has experience getting them open. Have the cable replaced and adjustment to the