Questions & Answers for: Panasonic adf sensor

...adf door. The door is closed, I have turned it off, unplugged it and am still getting the error code. In this case make sure that the plastic tab that actuates the sensor is not broken off. If it is, ...

...up to open) there is a small plastic sensor that dangles in the ADF, sometimes it gets push up and if it does it will give you this error. either you or a tech need to take it appart to fix the ...

Error code J93 on a Panasonic Workio DP 3530 it means the paper remains in the ADF [top part of the machine] . sounds like a stuck or bad sensor

... couldn't find any misfed paper. J93 means = paper remained in adf . sounds like you have a problem with the reed point sensor in the adf door . little black plastic arm , right side should be ...

...adf....I took out all parts of the jammed documetns and even attemplted to clean the sensors what should I do? yep! if it is j83 then the problem is in the duplex unit most probably the ...

...PUT INTO IT There is a switch under the ADF check and make sure that switch is engaged when ADF is closed Switch is located in the Middle of ADF right above the ADF Sensor on the machine platen ...

...a small piece of plastic that slots into a sensor toward the back of the adf. this small piece has broken off so the machine thinks the adf is open. an engineer would need to replace the door for

...software says its got paper in the feeder which it doesnt. Dust on the paper sensors is a common problem with ADF scanners such as this. Look at the paper sensor video on our web site for hints ...

the machine shows me that I have a paper jam on the adf but I don't see anything If it is showing a paper jam and you do not see it then you need to look for a small piece of paper that might have

junked the machine. I could find no valid cause for the error and did not have another ADF to put on it. If you can get into a diagnostics mode you may be able to test and find which sensor has failed