...error (ADF). Already dismantled the ADF to look if there still paper in it. Tried to find the tiniest paper that might cause the problem but found nothing. With the error, I cannot even use the flat ...
Question about X632 All-In-One Laser Printer
...error(046005 adf lamp failure) adf is not working or scanner There can be a few causes of this error: 1) Firmware Revision is not latest and lamp warm-up time is too short - update firmware first: ...
...Error Code 103, make sure that the ADF cable in the rear is connected to the scanner base. Check the flatbed to make sure that it is clear. A page incorrectly placed on the flatbed may interfere with ...
Question about PIXMA MX310 All-In-One Printer
...ADF error, Code : 2,103,0 Here's what I found. There were no stuck gears or pieces of plastic caught anywhere. The ****** can still feed paper, except for (consistently) the last page ...
...error between BICU and ADF The BICU does not receive a response from the ADF main board for 4 seconds or more. The BICU receives a break signal from the ADF main board. • Poor connection between the ...
Question about PIXMA MX310 All-In-One Printer
...error message: "Document in ADF. Close the feeder cover and press OK to eject document". There's no document in the ADF. Very frustrating. Is it worth repairing, as in cost prohibitive, or ...
Question about MX340 AllInOne InkJet Printer
...adf error Hi guys, This error occurs when paper sensor in ADF = Automatic Document Feeder detects some paper inside paper path. Firs, open ADF access cover and check if some broken paper present ...
ADF I/F error [F11] ADF I/F error (1) Check if the connector CN71 on the ADF/RADF board is disconnected. (2) Check if the relay connector between the ADF/RADF board and the PFC board is disconnected.
ADF cover is open The error indicates that the ADF cover is open, though it is totally closed. At first I ignored the error because when I opened & closed the ADF cover it comes back to normal, but ...
...Error 100005: ADF PID excess load error DESCRIPTION: The ADF motor stopped running in the middle of the operation 1. The ADF was stopped by - Obstacles such as jammed paper - Overload of the paper ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions