...ADF again, now opening the long grey cover on the backside, I disonnected the connector cable from both sides and - using a multimeter - checked this connector cable for breaks. Result: the violet ...
Question about ACULASER CX11NF All-In-One Printer
...ADF side under the cover) - you should check this first. Spare - part should be much cheaper. An other soultion can be, that the sensor - hook slid out of his mount. Hope this helps while trying to ...
...side of the document mat. If still same issue open the top cover of adf look on the rollers on the side and see if it is rotating. if all this steps fail adf has hardware problem and need to be ...
Question about ACULASER CX11NF All-In-One Printer
...not working on Epson Aculaser cx11nf printer The printer does seem to even recognize that it has an ADF. Unfortunately the book does give much info on what the problem might be. I tried unlugging and ...
cover, the printer also feeds four blank labels. What am I missing? Make sure, you firmware is right one for that printer because in most of cases it happens due to wrong firmware and bad ADF kits. so
...ADF cover and remove any jammed paper. Caution: Do not try to remove the paper without opening the ADF cover first, or you could damage the mechanism. 2. Press OK, then select Yes and press OK to ...
Question about WorkForce 600 All-In-One InkJet Printer
...ADF cover and pull any paper out to the left. Caution: Do not try to remove the paper without opening the ADF cover first, or you could damage the mechanism. 2. Select Yes or press OK to clear any ...
...ADF cover. Check thoroughly for fragments of paper and foreign objects. Take care not to tear any jammed paper when you remove it. Use the green gear (circled in yellow below) to turn the paper feed ...
Usually answered in minutes!
1,911 Questions
664 Questions
510 Questions
438 Questions
454 Questions