Questions & Answers for: acura 3 tl 97 check

...am looking for location of fuse box in acura 97 tl I have bad fuse but i cannot fine it. well there are 3 loactions it could be 1 under steering wheel driver side or behind the glove box or under ...

...acura 3.2 tl check engine light wont go off My check engine light wont go off no matter what unhook batterie 4 several min and hook back up if the light reappears take 2 auto zone have them test its ...

...acura tl. car still won't start i have a 97 acura tl. a mechanic said i needed to replace the fuel pump. i replaced it and it stll won't start. any suggestions? you need to have the fuel pressure ...

Acura 3.2 TL starts to overheat and I also notice that the air gets cold when the heater is on. But when I begin to drive after stopping, the temp. goes back to normal and the air gets back hot again.

...acura 2000 tl for check engine where is plug located for acura 2000 Tl, to check engine light with meter The OBDII connector is located in the center console just behind the ashtray. There is a ...

...is dead, I'd would the fuel pump on my 97' Acura 3.2 TL is dead, I'd would like to know how I can replace it? Thanks. well you have to drop the gas tank to do this there is to straps that hold it

...acura tl not shifting stuck on 3rd gear and check engine light and VSA light comes on. but okay after engine shut off and start up again This is the 4th time in 2 months period that this has happen. ...

...acura tl 3.2 To reset check engine light... Disconnect the ground (black wire) from the battery. Wait for at least a minute for the computer to reset, then reconnect the ground. Start your car, and ...

acura tl 3.2 2000 engine mis fired hi, my tl stall in the morning and engine light on #p0301 and 0303, after warm up is better, spark plug changed. any ideas, thx, mic the P0301 means Cylinder 1 ...

...Acura TL changed the fuel pump car runs good but now the TCS light and check engine light are on. the TCS light will come on any time the check engine light comes on. Pull codes from the engines ...