Questions & Answers for: ac module Cooktops

recived spark module for 6 burner gas stove on DCS gas oven/ Unable to see how I can exchange module for spark unit Unable to lif front plate w burner knobs in the way. Is the module behind this plate

Ad

Question about 30 in.JGD8430ADS Gas Cooktop

1 Answer

...module will not stop after lighting burner This is a Viking gas cook top professional series. Replaced spark module, now 2 out of 4 burners work. Spark module keeps igniting after gas is lit. The ...

Ad

Question about 30 in. JGP328 Gas Cooktop

1 Answer

...GE cooktop (JGP328WEC2WW) does not click or ignite.  How do I get to the spark module to replace it? Remove all the burner heads and lift the top. Sometimes easier said than done. How do you ...

Question about 30 in. JGP336 Gas Cooktop

1 Answer

all four burners will not ignite first chk the power outlet and make sure there is 120 v available.if it is ok.more likely it is the spark module which is bad.to chkd this remove all the burners by ...

...I need to clean/dry the electrodes, or seems more likely the Spark Module AP2020602 needs to be replaced. As this runs near $60, I would like to test the existing one to be sure it has failed before ...

Question about 30 in. Profile JGP932 Gas Cooktop

1 Answer

...switch or failed spark module. Unplug unit. Remove wires from burner switches at module and plug back in. If it starts sparking, replace module. If it stops, then replace switch

Question about 30 in. ACC3660 Gas Cooktop

1 Answer

None of the burners igniter clicks so none of the burners will light. Could the spark module have gone bad? That is definitely a possibility. If you can find the module you could disconnect the wire ...

Question about 30 in. ACC3660 Gas Cooktop

2 Answers

...wet somehow. Best thing to do is to unplug unit for 6-12 hours, allow to dry, then re-plug unit back in, this should be enough time to dry out the burner switches. Good luck i refurbish used gas ...

Question about 30" Electric Hybrid Induction/Radiant Cooktop - Stainless-Steel/Black

1 Answer

...at the cooktop input. Verify AC main input cables, screws and jumpers. Verify the fuse resistance to be approximately 0 ohms on the Induction Module. Replace the Filter Board on the Induction

Question about DR30DLP-H 30" Distinctive Dual Fuel Range DR30D

1 Answer

...AC using a simple plug usually. If you can locate the plug and reach it you may be successful resetting things by unplugging the cord, wait a minute or two and then plug cord back in. Try the burner ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...