Question about NordicTrack Treadmill, A2550
My NordicTrack EXP 1000 stops in the middle of a workout. Before it stops, I smell a rubber smell. 1) Does the tread need lubrication? 2) Is the motoer burning out? my nordic track 1000 stops several ...
Question about NordicTrack Treadmill, A2550
bad burning smell and turn off when i'm walking on it I have a Nordic Track A 1000i. Running on it last night, bad burning smell started ... EXP 1000 stops in the middle of a workout.what can i do. ...
the track stops when you put weight on it. It sounds as though you do not have enough tension on the running belt or the belt that drives the front roller from the motor is slipping. You need to ...
Question about NordicTrack Treadmill, A2550
the treadmill belt feels like it's stopping during my work out the drive belt needs replaced.
While using my Nordictrack a2550 this morning, the walking belt began to slip very badly. I checked the alignment and adjusted the tension of the belt as per the user's manual but the belt stills slip
Is it possible to operate a Nordic track A2550 treadmill without the key? If so, how? First thing I'd try is just using any magnet. I'm sure that's all the key is normally. If that ...
My Nordic Track A2550 starts but stops when I get on it. What's the problem? Watch this videos and tips:http://www.fixya.com/support/r10786838-test_procedure_dc_motorhttp://www.youtube.com/watch?v
Question about NordicTrack A2550 PRO Treadmill
a2550 motor belt still slipping after replacing it with a new one. and there is no ajustment on the dirve motor, what to do? Harvey, there are problems with the front plastic pully slipping on the ...
When I step on my treadmill it stops if it not yet been solved your problem, I suggest you the following: you should review the the motor brushes, or check the motor controller board.the component ...
Question about NordicTrack Treadmill, A2550
My norditrack A2550 pro bottom buttons do not work start, stop up or down the side buttons work but the treadmill does not run bad electrical connection on the circuit board for that array of buttons
Usually answered in minutes!
346 Questions
191 Questions
188 Questions
214 Questions
122 Questions