Questions & Answers for: a2250

Nordic Track A2250 Pro stuck inclined My Nordic Track A2250 Pro is stuck in the incline position. There was a knocking noise coming from the rear left (when on the machine) corner. I tried to fix this

my nordictrack a2250 only beeps when i press a command and nothing happens the console software is damaged and the console will need replaced

My nordictrack a2250 turns on, the incline works, display works - but even though it shows the belt to be turning at 1 mph - it's not moving and it doesn't sound like the motor is running. the motor ...

i have a nordictrack a2250 when run on it the belt slips i need to tighten the belt If your treadmill has had a lot of use, the belt has probably stretched and needs replacing. You can order a new one

nordictrac a2250 beeps when key is attached Nordictrac A2250 treadmill only beeps when the key is attached and any button is pushed. It does not move or incline and shows no display. adjust the reed ...

When I plug my Nordictrack A2250 in the fan runs and the screen is blue, none of the buttons work. This is without the safety pin attached. Adjust the REED switch, test it, clean it, and tight the ...

...number 146148, or ... tem is damaged, the walking belt may change speed ... ercising, the unique A2250 treadmill can be folded

Why does motor run about one second, then shuts down? If you wish to get some details; check the site linked here. Pull up older posts. Surf for article abort treadmill. ...

I have a norditrack A2250 model NTL 77806.1 everytime. I push any button on the panel it just beeps and nothing happen Possible control panel failure

A2250 treadmill starts for 2seconds then stops There might be an issue with the belt for your treadmill and the belt could be frayed or ripped or lose or broken. The belt has to be replaced with a new