Questions & Answers for: 98 degrees Cars & Trucks

degrees. Depending on what you have for thermostat, but normal would range from 195 F - 210F, or 90C - 98 C. For summer I'd stay around 180F-195F Depends on the vehicle but generally around 200 to 210

...is normal water operating temp 98 deville WELL THAT DEPEND BUT MOST THERMOSTATS OPEN AT 195 DEGREES SO DEPENDING ON DAY 200 TO210 NO MOOR BOILING POINT IS 113 DEGREES DEPENDING WHERE YOU LIVE IM ...

...on a 98 hyundai elantra The cylinder head bolts need to be torqued at 10MM bolts 22 FT-LBS 12mm bolts 26 FT-LBS + 60 degrees and then another 60 degrees.That torque will leave a blown gasket for

...98 ford escort a car with over 75k requires a slightly heavier oil so i would reccommend using 20/50,best you can afford. Depends on the weather, if its under100 degrees ferenheight 10w30 and if its ...

...98 1.8L (VIN M) engines- Tighten M10 bolts to 22 ft. lbs. (30 Nm), plus 60-65 degrees, plus 60-65 degrees. Tighten M12 bolts to 26 ft. lbs. (35 Nm), plus 60-65 degrees, plus 60-65 degrees.Hope this ...

...98 1.8L (VIN M) engines- Tighten M10 bolts to 22 ft. lbs. (30 Nm), plus 60-65 degrees, plus 60-65 degrees. Tighten M12 bolts to 26 ft. lbs. (35 Nm), plus 60-65 degrees, plus 60-65 degrees.Hope this ...

...98 degrees outside it started up but stalled atlights You'll have to figure out if it is a fuel or ignition problem.Is the check engine light on before the engine dies ?It can run in 125 degree ...

what are the torque specs wor a nissan patrol cylender head Engine ZD30DDTi 1.Tight to 98-102 Nm 2.Completely loose 3.Tight to 40-44 Nm 4.90 degree angle tight 5.90 degree angle tight

98 Honda accord psi on head bolts torque the head bolt to 22ft. lbs. then an additional 180 degrees ( if using new head bolts 270 degrees ) in sequence.

...98 caddy reaches 228 degrees make sure the rad cooling fans are running. if so don`t worry as I have had some engines run 215 degrees and higher before the fans activate to control the temp without ...