Questions & Answers for: Sta Rite 98 degrees

Sta Rite Sr333na Max E Therm Pool & Spa Heater gauge stuck? gas main was shut of for tenting of termites....after gas turned back on temp gauge is reading 126 degrees....no service lights are ...

R8 Error Turned on heater. LED says 125 then 126 then 125 - back and forth and back and forth. I set the thermostat to 100 degrees (spa was 77 degrees a tthe time). Then r8 appeared. What does this ...

I just replaced the Thermistor on my Sta-Rite Max-E-Therm 400 heater because the water temperature on the control panel was reading 202 degrees. It is still reading 202 Degrees with the new Thermistor

heater says 124 degrees... pool temp is only 76 heater wont fire up heater turned on shortly after stopped.. At the heater the temp showed 124 degree... pool temp is 78... Heater wont fire up bad temp

...98 degrees might have the wrong motor on it, themotor hp and SF sevice facto determin the total HP output of the motor. so say it's a 1hp with a 1.65 sf it's a 1.65 hp motor ..the impeller detrmins ...

I have a Starite 400 natural gas spa heater that I replaced circuit board last year and worked fine thereafter. This year when I fire up the spa, once the temperature of the water hits 100 degrees the

heater only warms water to 98 degrees Heater will not heat water temperature higher than. 98 degrees temp sensor or if control box make sure heater set to 104

display reads 68 degrees and pool is 84 degrees My Sta-Rite model SR200NA heater is displaying a lower pool temperature at the display. My actual pool temp is quite higher than the display reads. This

my sta rite will not shut off, it runs all the time, the pool temp is up to 98, i have already replaced the Thermistor. The digital read out on the heater says its on 33 while its actually 98, I would

My sta rite ignites and runs for a few minutes and shuts off and repeatedly reignites. My pool water is only 63 degrees. If I turn the temp up to 90 degrees, it will run continuously. No service light