Questions & Answers for: 91 honda accord brake lights

91 Accord has 2. One on each side in the smaller of the 2 rear tail light lenses. In order to change the module you have to remove the smaller of the rear tail lights. Drivers side is 5 pin. Passenger

91 honda accord lx stays once put into park it stays stuck.can get it to come undone by putting a key into the shift lock..could this be a relay problem..if so where is it located My 91 accord had the

...91 Honda Accord has 2 separate tail lights on each side(total of 4 pieces). My problem stemmed from a faulty control module on the right hand side(passenger side). The module in question is located ...

...91 honda accord and when i turn off my car the rear brake lights don't turn off. How do i get them to turn off?? What is the problem??? Attached to the brake pedal, on the back side, is a switch, ...

91 honda accord brake lights stay on replaced 91 honda accord LX brake lights stay on, replaced brake light switch .still stay on operated brake switch manually.still staying on. any suggestions? are ...

...91 honda accord ex It would be on the brake pedal under the dash. Sometimes they come loose, and just need to be repositioned. There is an excellent site for Hondas at 3geez.com good luck. chec the ...

91 accord cant find a short anywhere, looking to run new wires to make it work, any tips there is a swtich on the brake pedal you have to get on the floor board and look you should see the swicth

91 honda accord emergancy brake light turns on randomly I am have a 91 Honda accord and recently I ve noticed the emergency brake light (red one on the dash board) will turn off and on randomly even ...

my honda accord 91 would not come out of park i had a burned out fuse to the brake lights check your brake lights if their out check your fuse that should fix your problem its a 20 amp fuse

...box. this e how pretty mutch explains the whole troubleshooting prosess: How to Troubleshoot Brake Switch on Honda Accord eHow altho image is for the 02 honda accord the 91 uses the same switch ...