...80W-90, 85W-90 or 85W-140 varies from what temperature range, climate. I used 10-30 but you can use 20,30,10-30 weights. It does seem too thin but that is what haynes repair manual says it calls
...90. 30+30+30=90. and so forth. I don't know your application but they sell larger radias 90 degree rigid conduit elbows at Home Depot or Lowes. buy a TruCut or Total Cut Pipe Guide -- online or at ...
...for a 1999 ford tauras 3.8l 1st - step; - 30 ft./lbs. 2nd - step; - turn 90 degrees 3rd - step, loosen 1 turn; 4th - step; - 30 ft./lbs. 5th - step; - turn 90 degrees 6th - step; - turn 90 ...
...30 Automatic Transmission,31TH......AP3 Synthetic Multi-Vehicle Automatic Transmission Fluid (ATFQT) Automatic Transmission,41TE......AP3 Synthetic Multi-Vehicle Automatic Transmission Fluid (ATFQT) ...
...angle gauge - add another 90-degree to it 4. Loosen head bolts by one turn 5. Again, torque them to 30 ft-lb 6. Add another 90-degrees 7. Finally, add another 90-degrees using a torque angle
...boltsstep 1 30 ft lbs.step 2 additinoal 90 degreesstep 3 loosen all bolts 360 degreesstep 4 30 ft lbs.step 5 additional 90 degreesstep 6 additional 90 degreescamshaft bearing cap bolts 89 inch
...90 sec main burner goews out. same results in 30 sec then 60-90 sec and repeat 30 60-90 After burner on did you hear any spark ignitor if that your flame sensor is dirty or need to replace....good ...
Question about DFG-100 Gas Single Oven
!st step, tighten in sequence to 30 ft lbs. 2nd step, turn 90 degrees. 3rd step, loosen one fuel turn. 4th step, 30 ft lbs. 5th step, turn 90 degrees. 6th step, turn 90 degrees. do not reuse old bolts
Question about DFG-100 Gas Single Oven
...30 Nm (22 ft lb) + 90° To measure radial clearance Tighten 30 Nm (22 ft lb) but NOT additional 90° TIGHTENING SPECIFICATIONS Oil Pump Bolt 20 Nm (14 ft. lbs.) Oil Tube To Block 10 Nm (7 ft. lbs.) ...
Question about DFG-100 Gas Single Oven
...30 Nm (22 ft-lbs) + 90 degrees + 90 degrees (in 3 steps of 90 degrees each) Main bearing cap bolts torque: 30 Nm (22 ft-lbs) + 90 degrees Connecting rod bolts torque: 25 Nm (18 ft-lbs) + 90 degrees ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions