...6300.2 TREADMILL IS SHOWING A E3 EROR ON THE DISPLAY WEN START THE MACHINE CYCLE ERR 3 Troubleshooting Inspect the optic sensor and other components as follows. Optic Sensor 􀁺 Optic ...
errow mesage E 1 One of the more common error codes on treadmills with DC drive motors is the E-1 error. This error may occur when you try to start the belt, preventing it from starting up or it may ...
6300 sports art wony incline at all hi check inline fuse if you start it and incline reads more than o when pressed it is fuse it is lokacted on motor controll board there is 2 one for drive motor one
E6 error - incline not responding. Replaced 1A fuse but still not working I'm getting the same E-6 error while running in program mode although the fuse is fine - and when I recycle power, the program
15A fuse going out. Replaced 3 with no success, spark on low end of board after about 5 seconds, thenn fuse went.. Unplugged power wires to the lower board, powered up treadmill and the fuse survived.
Fuse blows at the onset of starting the track Purchased a new EMI Filter. The symptoms are the same. disconnect the motor from the motor control board under the motor hood ( follow the wires from the ...
Usually answered in minutes!
43 Questions
2 Questions
2 Questions
3 Questions