Questions & Answers for: Mitsubishi 5a fuse

5A fuse was burnt out. I replaced this fuse. I tried again but same thing - push power button, little green light goes on in the front for a few seconds but then goes off and no picture or anything...

...that might cause this? Check fuses F9A04 and F9A05 (5A micro fuse)on the board in the middle.If one or both are open than you need to change both the convergence IC's (STK392-570)along with the

...original Mits # times two............T. Check fuses..................Let me know...... Check 5A micro fuses F9A04 and F9A05 - If one or both are open change both convergence IC's =

...or two the it powers back down. The screen is not turning on at all. Check the soldered in green 5A micro fuses F9A04 and F9A05 at the rear center of the middle board - If one or both are open,

...5A fuse was blown. After replacing it, the set worked for about 1/2 hour and the problem really was the "switching transformer had a shorted winding. Hi Solaron, I've tried replacing the 5A fuse but ...

Blown fuse I have a blown pico 125v 5a fuse, can I replace it with a different type of fuse? What was the orginal problem?

...fuse blows, the voltage from the power supply that keeps the set on disappears. The 5A fuses that keep the plus and minus 24v rails going are little green things that look like resistors, but are ...

...fuse is this something i can do or should i call in a technician? where is it located on my set? It is mounted to the case that holds the lamp.. Its specs read something like L3 250V, 5A, 115C. You ...

...42" Mitsubishi HDTV that needs a 125v 5a pico fuse. Having trouble locating a local store in the DFW area to get parts. Does anyone know a source to get these parts? Click here to find the pico

...Code 2-2 My Mitsu 46809 powers on, the off in abot 2 seconds. Error code is 2-2. Fuses FA904 (125V, 5A-- 24V supply?), and FA905 (125V, 5A-- neg 24V supply) are open. These are on the middle board ...