Questions & Answers for: fit 2 bell housing

Question about GE Microwave Ovens

1 Answer

...2 deep..I have purchased a PEB2060DMCC in bisque and a trim kit PEB2060 but installer says the microwave cabinet hole is not deep enough to install..what microwave in bisque will fit the custom ...

Ad

fit a 2001 dodge truck,auto tranny, 2 wheel drive 1994 dodge truck 2 wheel drive ,both have 318 engine,auto tranny fit in 2001 dodge truck, if not what years will fit Yes they will both match up. Just

Ad

Question about 2001 Ram 1500 Truck 2WD

2 Answers

2 ton V-6 Van, I snapped off the outer nut holding the negative lead I now have the inner nut which is holding the starter and I cannot get it loose, I put some heat on it with a torch, no luck also I

...2 wheel drive. Finally, as the exhaust system may be different, you may run into problems where the smaller pollution controls are hung in slightly different areas to fit the different vehicle you ...

...there were 2 different ones and you have to put in what you took out. I'm not 100% sure but I think they were electronics changes so it may physically fit but won't work properly. Hope this

2 door and want to replace the 6vd1petrol for a 2000 model 4jx1t diesel What problems can i expect gear box to rear engine bolt pattern in the bell housing unless you change engine and transmission as

Question about 1998 Wrangler

1 Answer

...fit, the short block. In 1986 the head went under a minor revision, the head bolts were increased from 7/16 to 1/2 inch. id bet that be lowest year. http://www.allpar.com/mopar/amc-25.html any with ...

Question about 1998 Wrangler

1 Answer

...fit gearboxes behind it . IT is a standard 1 or 2 housing and by knowing this it cam be decided if a certain box used in heavy vehicles will fit behind the engine . Having said that there may be an ...

...fit a trolley jack under the g/box and another one under the engine sump, remove remove all parts as required under the bonnet such as top hose any hoses pipes cables and battery term (neg) g/b/cross ...

...bell housing all the way around and recheck for bolts you've missed. Some transmissions have bolts fitted from the opposite side, often holding other things in place like the starter motor. The ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Microwave Ovens Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Cindy Wells

Level 3 Expert

6688 Answers

john h

Level 3 Expert

29494 Answers

Are you a Microwave Ovens Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...