...4K. With the Gerbing jacket and heated grips on full blast it goes down to 11.9. Here's where I'm lost. To check the alternator, the manual says to pop the infamous brown connector (which is not even ...
...engine dies. Does anyone know what would cause stronger idle when the cable is not completely plugged on the plug? Thanks maybe when you are pulling the wire just a little you are making a better ...
engine to idle and adjust L CW so that the engine runs fairly well, but allows the engine to 'follow the throttle'. Adjust idle speed screw so that the chain stops turning, but the engine continues to
Question about Chain Saw Handle Models 50 51 55 154 254
...throttle and adjust L needle CW for better idle, yet allows the engine to 'follow the throttle'. Adjust idle speed so that the chain stops turning, but the engine continues to idle. Hope this
...L needle CW for better idle, but still allows the engine to 'follow the throttle'. Set the idle speed screw so that the chain stops turning, but the engine will continue to idle. Hope this
the engine idles fairly well, but still allows the engine to 'follow the throttle'. Idle speed screw should be adjusted to keep the engine idling, but the chain should not try to turn. Hope this helps
idle speed as the engine stops. start by checking all ur fuel lines for holes then proceed to clean or rebuild ur carb the ethonal in fuel is cloging small engine carb jets and making needles stick so
engine runs smoothly at idle speed, around 1200 RPM. The high speed jet is adjusted to 1 1/2- 1 3/4 open from the bottom seated position, after the engine is warm. Then re-adjusted by turning the High
Question about Craftsman 36cc, 16 In. Gas Chain Saw
...engine to run and idle fast (idle adjust) so it doesn't stall, adjust low-end screw so that engine doesn't hesitate or sputter when accelerated. Adjust high-end screw to run fast and smooth on full ...
...idle port may be partially blocked.. the easiest way to clean it is start the engine and cover the carb inlet with the palm of your hand after 2 or 3 times of the engine stalling. Restart and problem ...
Usually answered in minutes!
31 Questions
17 Questions
16 Questions
16 Questions
15 Questions