Questions & Answers for: channel amplifier mtx

mtx blue thunder pro3002 my older amp left channel output blew i think. the fuse blew and now there is no sound on the left channel. what can i do? Take this apart and look at the magnet wire windings

...MTX 502 bridged into 2 ohm load. Power system up seems a little weaker than normal. Unhook left rca wire...no change in output. Plug left rca back in unhook right.. silence turn gains up no help... ...

...amps. Make sure your speakers can handle the watts or better the RMS power. Must amps that are rated at 1000w only mean 500RMS. A 4 channel amplifier rated at 1000wats means to me 125RMS per

...Channel Amplifier and it blinks about 12 times then stays bright for one second and rapidly blinks again....repeating the same pattern. ..............------...............------ WHAT IS IT DOING ...

...channel. Hello jaimemm_77, The MTX 421d is a mono amp. It only has one output channel. If you are asking about hooking up only one channel to the input, then no, the amp will not overheat. But the ...

...to one output. The MTX 81000d is a single channel amp so it cannot be bridged. Hope this helps. tengo un mtx 81000d necesito saver valores de unos componentes escribime ...

how mant watts is the mtx 4002 my guess is that it would be a 400 watt 2 channel wich means 200 watts per channel or you could prob bridge it to make a full 400 watts to one channel

my mtx 502 was going into protection mode, but now wont power on. ineed a diagram of inside the unit http://www.retrevo.com/support/MTX-502-Car-Amplifiers-manual/id/23108bh332/t/2/ service manual for ...

ayuda con el MTX THUNDER 895 mi pregunta es: cual es el precio de este amplificador""MTX THUNDER 895"" esq un amigo me lo vende y kiero saber cuanto cuesta y tiene otro detalle me dice que las salidas

...one channel The mtx thunder is a 4 channel amp. 4 channels can't be bridged to 1 speaker. You can only use one side of that amp to bridge your speaker. Unfortunately your now only using half your