Questions & Answers for: Dodge Intrepid 4 3 tps sensor

Question about 2002 Intrepid

1 Answer

...tps sensor or a stuck throttle linkage. the tps is located on your throttle body and has a 2 or 4 wire plug the throttle linkage is located in the same are have this looked at... please rate ...

Ad

...TPS/Pedal Pos Sensor A Circuit Low P0731 Gear 1 Ratio Incorrect P1776 Manufacture ctrl trany..... P0841 Trany Fluid Pressure Sensor switch... P0340 Camshaft Position Sensor Sensor A Bank 1 P0335 ...

Ad

Question about 2000 Intrepid

1 Answer

...body i know one is the tps i dont know what the other is, is it the mass airflow sensor? thanks the other connector on ur throttle body it the idle air motor. that controls the idle of the

Question about 2000 Intrepid

1 Answer

!! Check IAC sensor and TPS and MAF sensors if IAC is ok. IAC will amke your idle go up and down all crazy and cause stalls when slowing down or releasing throttle but TPS and MAF also can effect this

...Recirculator bad TPS It's most likely a combination of the 3 but the main cause would normally be the TPS (Throttle Positioning Sensor) which regulates engine idle speeds under different

Question about 1995 Intrepid

1 Answer

...tps sensor correlation code, essentially it means the map sensor reading isn't what's expected with the tps reading and vice versa! It sounds like your tps sensor is probably bad or the ...

...sensor and cleared codes. about 100 miles later drove to work, 8hrs later started it and engine started intermittently revving at idle and in gear. had to keep heavy on throttle to get it home.shut ...

...TPS map sensor, cam sensor, checked all grounds, checked EGR valve, checked high side AC switch, and unplugged transmission. Engine still will surge and set code P1469 but only in reverse. Have ...

...tps sensor as well as tested it ive took a meter and hooked up the red probe to the violet wire and the black probe to the battery ground with the ignition on and the reading was 5 volts but I heard ...

...tps twice It may be that no signal is better than a faulty signal? With no signal the computer may use a default value? Any applicable trouble codes? If the sensor has three wire connector, did you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Manuals & User Guides

Loading...