...roller rockers on it, drove it some 400+ miles started hearing a slight tick on driver side 1st thought was headers ,2nd was push rods . we removed the valve cover driver side and found that the very ...
...for checking the clearance between the top of the valve and the rocker arm in a 253 Holden V8? we are using hydraulic lifters and roller rockers with the adjustment screws. feeler gauges work
...pushrod i got from summit raceing i have a 302 ford with roller rockers put the rocker arm on get lifter on backside of cam ajust pushrod so rocker tip is in the center of valve then measer ...
we have found some needle rollers in the sump of our holden (Buick) 3.8 engine. where would these have come from. There is no Holden Commodore listed below so i have just chosen a buik to get throught
Question about 1966 Mustang
...box tapping loud on a 2000 harley road king fuel injected Have you had any engine work or head work done? Installed bigger valves or roller rockers? If so, the rocker boxes need to be
...roller rockers... Intake.. And headers... I have a knock or loud tick it the head... Right behind header on the right side of motor... It's sounds more less like sounds like something it rattling ...
Question about 1966 Mustang
a small block chevy built up kind of, big cam, new 1.5 roller rockers. What could be the problem? Check the ignition timing, you may be a tooth out on the rocker camshaft, if it's an overhead camshaft
Question about 1966 Mustang
...only part im stumped on is how to adjust rocker arms never done this before what do i need to do not roller rockers just factory There is no adjustment , install rocker arms an torque to 18-28 ...
...rockers double roller timing chane when spinning moter it is spitting back out of the carbs I be leave it has somthing to do with the timing but I'm on TDC on #1 wired right triple checked If that ...
Question about 1966 Mustang
roller rockers) https://www.j-car.org > forums > read Dec. 8, 2005 - The hydraulic lifters adjust valve lash automatically. All you need to do is torque your top nuts on your rocker arms down to 22 ft
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions