sensor error (belt marker). Could be a piece of paper or such stuck in there from a previous jam futzing up the sensor. Are you comfortable poking around inside your printer? Check the OPC belt on the
...Error 50 code returned. I checked to see if any paper was stuck somewhere in the printer. There was none. Error 50 is a fuser unit fault code. You can take apart the fuser unit and see if the fuser ...
...error) If the registration sensor is ON, the lower paper cassette solenoid is turned ON, and the Ready LED also stays ON. (HL-1250 only) NOTE: The lower paper cassette solenoid is turned ON/OFF even ...
...error code ed 6 what i can do plzzzzzzzzz You get this error code due to defective or failing paper width sensor . The sensor located just to the left of the Print head Assembly, is the Paper Width ...
...error code E50 indicates a fuser unit failure - the fuser unit is no longer working and needs replacing. The error may also display itself on your Brother printer's front display panel as "Fuser Unit ...
...Hi I have a Brother HL-6050D/N that comes up with Error code E60. What is error code E60? E60 says the fan is not working, I would try first to blow it out, and after that look for a replacement
...error code. shutting off and back on does not work This is a density sensor error. Check if there is a scratch, dirt or the like on the belt unit. If so, replace the belt unit. Check the connection ...
...error 37 mean? Thank you! Belt unit temperature sensor failure. Step 1: Cause: Belt unit temperature sensor harness connection failure Remedy: Check the harness connection between the belt unit ...
error indicates one/more of the following. 1. The fuser roller/film life is over. Replace with new one 2. The fuser film is torn. Replace with new one. 3. Fuser heater is burnt. Replace the heater. 4.
Usually answered in minutes!
1,072 Questions
495 Questions
422 Questions
377 Questions
249 Questions