Questions & Answers for: Chrysler Town & Country error code replaced sensor

error code. Then the odometer lights will flash, a bunch of error codes flash. Let it finish. I found this on fixya before, and it worked for my van. I didn't replace anything. my 2001 ac quit working

Ad

Question about 1996 Town & Country

1 Answer

...Error Code Hi, My check engine light of my 1999 Honda Odyssey came on recently. The error code read was p0420. Wondering whether this has to do with Catalytic Converter or the O2 Sensor? Thanks. Cat ...

Ad

Question about 2007 Town & Country LX New Cars

2 Answers

error code include: Check for exhaust leaks at the manifold, pipes, catalytic converter. Repair as required. Use a scope to diagnose the oxygen sensor operation (Tip: The oxygen sensor in front of the

Question about 2007 Town & Country LX New Cars

1 Answer

i have a 2006 chrysler town and country and i got an error code - P 0406. what part do i need to repair or replace? P0406....Exhaust Gas Recirculation Sensor 'A' Circuit High

Question about 2001 Town & Country

3 Answers

...error code on my tranny after repair,wat can do this error thanks I just went the this replaced both speed sensors (input/output), l then looked under my car Some one had replaced my sensor on my ...

error codes but need help understanding them, and figuring out what I need to replace and where it would be located on a 2005 Chrysler T & C,self test codes are (0016 Bank 1 Sensor A) = Crankshaft

Question about 2004 Town & Country

1 Answer

error code p0032 on town and country 3.8L engine. I replaced the bank1 oxygen sensor but still have the error code and check engine light is still on. installed brand new Bosch oxygen sensor. What ...

Question about 2005 Town & Country

1 Answer

...error code reads PO138. We have replaced the spark plugs and wires, the ignition coil, a fuel injector, the computer, the catalytic converter, and the downstream oxygen sensor. Now We are getting a ...

Question about 2001 Town & Country

2 Answers

...error codes P1684 It is not a fault code per say, it only indicates the battery has been disconnected or went dead in the last 50 drive cycles I believe. P1683 This code refers to the cruise control ...

Question about 1996 Town & Country

1 Answer

Error codes 736 How do I reset the codes for the output speed sensor, 729,reverse incorrect gear ratio 736, gear 1, 731? DISCONNECT BATTERY ,WAIT 3 MINS RECONNECT. SHOULD BE GOOD UNLESS A HARD FAULT, ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...