Questions & Answers for: 3 4 motor surge

motor is running at idle speed it surges up and down but when i pull the trigger on the wand it runs smooth Try a simple test. It is ok to run the pump without water for a short time. Check idle speed

Motor surges We have a Kitchen Aid Pro 600 and the motor surges at low speeds http://downloads.mendingshed.com/KitchenAid_Service_Manual.pdf See the section on repairs to speed control / motor.

Motor surges rpm while blasting with pressure washer. There is a short arm that moves up and down. I can hold it in place and the motor will stop surging. That lever is the governor. It's not ...

...motor or controller board. How do I tell? I've adjusted and lubricated the belt. Use only a single-outlet surge suppressor that is UL 1449 listed as a transient voltage surge suppressor (TVSS). The ...

motor surges when stopped at a light. RPMS go up ... Motor surges when stopped at a light. Rpms go up and down replace the idle speed control motor

...off the gas motor wants to surge. also, when motor is hot and you put into reverse, it sometimes the rpm will drop and motor will shut off. I suggest check for vacuum leak and test fuel

...motor surge as well? Does water come out of the bottom of the pump? Does nothing come out of the spray gun when the trigger is squezed? All of these symptoms point to different problems. What does ...

...surge,the faster you go the faster it surges,what could cause this? Surging is usually at the throttles and idle air control motor. Cleaning them usually takes care of this problem. I haven't worked ...

motor starts there is always a high current draw ( surge ) and that is why there is a surge rating for the inverter but that surge is for a second or less so the components of the inverter will handle

mower starts, but surges motor surges but runs better when blades are engaged May have problem with governor on motor. Or if old motor could have problem with throttle shaft in carb. Change fuel you ...