...80) as set out in the Table. THEN if apart assemble the forks as follows: a. FXD, FXDXT, FXDWG models: install both fork tube caps and tighten them to 11-22 ft-lbs (14.9-29.8 Nm). b. FXDL models: ...
35. P2135 TPS Correlation Error 36. P2119 EFI Motor Throttle Body Range Performance 37. P2100 EFI Motor Circuit Open 38. P2101 EFI Motor Circuit Range Performance (Actuation Error) 39. P2102 EFI Motor
...80) as set out in the Table. THEN if apart assemble the forks as follows: a. FXD, FXDXT, FXDWG models: install both fork tube caps and tighten them to 11-22 ft-lbs (14.9-29.8 Nm). b. FXDL models: ...
...80 Historic 25 Rear ignition coil open/low 81 Historic 24 Front ignition coil high/shorted 82 Historic 25 Rear ignition coil high/shorted 83 Historic 24 Front cylinder combustion intermittent 84 ...
...torque specs Front engine mounting bolts 70-80 ft-lbs Transmission mounting bolts 30-35 ft-lbs criss-cross pattern Top engine mount bolt 45-50 ft-lbs Engine/transmission bracket bolts 30-35 ...
80 Historic 25 Rear ignition coilopen/low 81 Historic 24 Front ignition coilhigh/shorted 82 Historic 25 Rear ignition coilhigh/shorted 83 Historic 24 Front cylinder combustion intermittent 84 Historic
...80 in-lbs (6.8-9.0Nm). The FXCW/FXCWC Solo Seat is attached with 2 locating pins that for removal must be removed from their grommets by lifting the rear of the seat, then the seat is pulled to the ...
...80 Historic 25 Rear ignition coil open/low 81 Historic 24 Front ignition coil high/shorted 82 Historic 25 Rear ignition coil high/shorted 83 Historic 24 Front cylinder combustion intermittent 84 ...
Question about 2000 FLHRCI Road King Classic
...and starter motor Hi Laurie, the values are as follows: 1/4" bolts 10 ft lbs.-- 5/16" bolts 20 ft lbs.--3/8" bolts 35 ft lbs.---clutch hub nut 80 ft lbs.---compensating sproket 165 ft lbs. Good ...
Usually answered in minutes!
159 Questions
136 Questions
123 Questions
113 Questions
100 Questions