how do I remove the primary to get to my primary shift lever on a 2005 harley super glide This is a major job. Far too much information for this forum. It will require a lot of typing in this small ...
...80) as set out in the Table. THEN if apart assemble the forks as follows: a. FXD, FXDXT, FXDWG models: install both fork tube caps and tighten them to 11-22 ft-lbs (14.9-29.8 Nm). b. FXDL models: ...
...80) as set out in the Table. THEN if apart assemble the forks as follows: a. FXD, FXDXT, FXDWG models: install both fork tube caps and tighten them to 11-22 ft-lbs (14.9-29.8 Nm). b. FXDL models: ...
1992 fxrs. just split my Final drive belt, can I fix it at home? ok/good mech. knowledge but will I have problems with clutch etc. Any "traps" or handy tips would be good. yes, you can ...
...distance from directly below the front axle to the base of the screen/wall, draw a horizontal line 35 in. (0.9 m) above the floor on the screen/wall, load the motorcycle with a rider, and passenger ...
torque specs for installing the triple tree jhow do you adjust the drive belt? Hi Anonymous, 30-35 ft lbs. for more information on your question please visit the websites below and good luck. ...
Question about 2002 FXD Dyna Super Glide
...and starter motor Hi Laurie, the values are as follows: 1/4" bolts 10 ft lbs.-- 5/16" bolts 20 ft lbs.--3/8" bolts 35 ft lbs.---clutch hub nut 80 ft lbs.---compensating sproket 165 ft lbs. Good ...
1450CC engine produces 67-68 HP Google thinks it is rated at 65bhp but gives two fuel consumptions; 35 or 43 mpg, which by European standards is very poor fuel efficiency. Hi, Roger your Dyna delivers
Question about 2003 FXD Dyna Super Glide
1976 Harley-Davidson FXE Super Glide. Complete wiring schematic for 1976 Super Glide FXE please? Question edited for clarity and add maker. Question moved from Cars and Trucks category. Check out the ...
Usually answered in minutes!
137 Questions
126 Questions
109 Questions
61 Questions
45 Questions