Questions & Answers for: Chevrolet 35 80 Computers & Internet

...35 series) 108 Nm (80 ft. lbs.) Caliper Mounting Bracket Bolt Rear (JC5/JH5) 200 Nm (148 ft. lbs.) Caliper Mounting Bracket Bolt Rear (JH6) 165 Nm (122 ft. lbs.) Caliper Mounting Bracket Bolt Rear ...

Speedometer on a 1991 chevy silverado reads 80 when only going 35-40. your spedo cable needs to be replaced and re adjusted

80$ but you can go to pick an pull and get a set of 4 for about 35-40$ and they are VERY weasy to remove 4 bolts for the fuel lines remove the plastic clips for the wires a retaining clip for each one

80 on the gauge, checked the oil added a qt, but still have the same problem. would like to if it is something simple to repair myself. it fluxuates when either driving or idling. Most likely it's the

...80 inch lbs. (9 Nm) and the "S" terminal nut to 22 inch lbs. (2.5 Nm). Position the starter motor to the engine and install the retaining bolts/screws. Tighten to 35 ft. lbs. (47 Nm). Measure the ...

...35°C (86-95°F) Below 30% 266-386 kPa (39-56 psi) 1500-1940 kPa (218-282 psi) 21°C (70°F) 30-50% 280-397 kPa (41-58 psi) 1540-1990 kPa (224-289 psi) 22°C (72°F) Above 50% ...

...80 when i start driving and get to about 35 mph my oil pressure drops to 0 then anywhere from 5 to about 30 seconds after it comes back up to 80 psi. it just keeps jumping up and down while driving. ...

...35 mph the gauge will drop to 0 and then come back up to 80 psi. any where from 5 to 30 seconds the gauge will go back to 80 psi after it drops. it just does it randomly. if anyone can help it would ...

...35-40 PSI on the low end and 190-200psi on the high end (paperclip installed). Everything works "proper" at this point. Once paper clip was removed and relay has been re-inserted compressor ...

...80 ft lbs. Inner & Outter Tie Rods - 35 ft lbs. Centerlink - 35 ft lbs. Idler - 35 ft lbs. Upper control arm shaft - 92 ... Torque specs for rear control arm. ' Chevy Impala SS Forum Oct 5, 2003 ...