Questions & Answers for: 35 80 Cars & Trucks

...80 speedometer reads too high the speedo reads high whiles driving, when driving at an indicated 50 mph i'm actually doing 58, this has been gps and followed by another car verified. indicated 35=40 ...

...35 series) 108 Nm (80 ft. lbs.) Caliper Mounting Bracket Bolt Rear (JC5/JH5) 200 Nm (148 ft. lbs.) Caliper Mounting Bracket Bolt Rear (JH6) 165 Nm (122 ft. lbs.) Caliper Mounting Bracket Bolt Rear ...

...35 mph and then again at about 55mph. Tachometer doesn't move with the motion of the jerking caused by the lack of gas or whatever it is. Sounds like a range sensor problem! It mite be bad and need ...

Speedometer on a 1991 chevy silverado reads 80 when only going 35-40. your spedo cable needs to be replaced and re adjusted

...35 mph to 80 i have a 96 a JGC zj at 35mph all the way up to 80-90 mph it has a slight studder almost like its misfiring i replaced plgs wires cap rotor iac sensor the codes its showing are injector ...

...80 km/h (35 - 50 mph) for 10 minutes or more, fully close the throttle at least once in 2 minutes and decelerate for 10 seconds or more. Do not repeat deceleration too often. Vehicle speed may go ...

...a 98 4.0 jeep on rods and mains. Tighten all main bearing bolts to 108 Nm (80 ft. lbs.) torque. Install the main bearing cap brace. Tighten nuts to 47 Nm (35 ft. lbs.) . Connecting Rod Nuts 33 ...

...specs for the harmonic balance on a 2004 pontiac grand am V6 3.4 liter. I always use 80 foot pounds no matter what GM engine it is. After 35 years of rebuilding engines none has a problem ...

...35 mph the gauge will drop to 0 and then come back up to 80 psi. any where from 5 to 30 seconds the gauge will go back to 80 psi after it drops. it just does it randomly. if anyone can help it would ...

...80 ft lbs. Inner & Outter Tie Rods - 35 ft lbs. Centerlink - 35 ft lbs. Idler - 35 ft lbs. Upper control arm shaft - 92 ... Torque specs for rear control arm. ' Chevy Impala SS Forum Oct 5, 2003 ...