...90 degrees in same sequence. 3.1L - cylinder head bolts: coat threads with sealer tighten to 33 ftlbs starting from center front in spiral pattern; then tighen bolts an additional 90
33 ft.lbs then 90 degrees more and then another 90 degrees more it just seems like too much torque If these are the instructions of the head bolt manufacturer then this is correct. These are torque to
...Pump Mounting Bolt 16 (22) Shift Cable Bracket Bolt 16 (22) Timing Belt Tension Adjuster 33 (45) INCH Lbs. (N.m) Timing Belt Cover Bolt 108 (12) Valve Cover Nut 90 (10) Water Pump Bolt 108
3 vz-e engine cylinder head torque specifications 33 ft-lbf then 90 degrees then another 90 degrees
33 ft.lbs. Step 3- 90 degree turn Step 4- 90 degree turn 4.5L is: Step 1- 27 ft.lbs. Step 2- 90 degree turn Step 3- 90 degree turn Norh American cars and trucks usualy go to 65 lbs. I need help to see
90 Battery Voltage : 12 volt Battery Weight : 33 lbs. Battery Width : 7" Wet or Dry : Wet A lead acid battery with the fallowing specs group 75 Attributes Battery BCI # : 75 Battery CA @ 32 Degrees F
per head bolt. You did not specify what motor.So I`ll give you both.The 3.1 is 33 ft.lbs.and additional 90 degree angle.The 3.4 is 44 ft.lbs.and an additional 90 degree angle.Hope this helps.Good luck
...the torque settings for the cylinder head on a toyota prado 3.0td.thanks 12-point bolt head step 1. 33 ft lbs. step 2. additinol 90 degrees. step 3. additinol 90 degrees. 6-point bolt head. 30 ft
...cylinder head bolts to 48 ft lbs. then remove all head bolts and oil threads. then torque all bolts to step 1 22 ft lbs. step 2 33 ft lbs. DOHC 37 ft lbs. SOHC step 3 additional 90 degrees good ...
touque spec. 1995 v 6 toyota four runner '95 3.0L V6 head= 1st- 27 ft lbs, 2nd- 33 ft lbs, 3rd- 90 degrees, 4th- 90 degrees
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions