...wont start If the truck has good batteries and cranks well.--- There is a schrader valve on top of the fuel filter housing, (it looks like a tire stem valve) depress this valve while someone cranks ...
...wont start, it will turn over but will not start. 1. Make sure that the battery is fully charged. 2. Check the fuse for fuse # 30. This is the fuse for the: Fuel Heater (Diesel only), Wastegate ...
...wont charge. I have new batteries and an alt. still no charging. Could this be the 300amp fuse. where is that located. When i got the truck back the oil dipstick mount was off inside the oil pan. I ...
Question about 2002 F350 Super Duty DRW Reg. Cab
...wont come on. turn the key on and blows #30 fuse. that fuse powers pcm fuel heater and some other things. when the fuse blows the pcm shuts down. causing it to not run. usually its the heater that is ...
...wont start 1999 f-350 won't turnover can jump solenoid and it starts thinking its the trs was wondering how to test it Turn the key on and leave it on for ten minutes,then turn it off,and right back ...
Question about 2000 F350 Super Duty Super Cab
wont start truck didnt start changed the fuel pump it started left it running for 20 min then turned it off try to start it again but never started again tried for 30 min but did not start Fuel filter
...wont stay running Never, ever use starting fluid in your diesel. Taken from the Owners Manual - Diesel Supplement: Do not crank the engine for more than 30 seconds at a time as starter damage may ...
...generator adjusting arm to water pump with one attaching bolt. Tighten 7/16-inch bolts to 54-71 Nm (40-53 ft. lbs.) and 3/8-inch bolts to 41-54 Nm (30-40 ft. lbs.). -Position A/C compressor mounting ...
...wont turn over replaced clutch safety switch ck starter relays can b pull started Did you check for power at the starter ignition terminal? It is the small YELLOW/BLACK wire on the starter. If there ...
...wont start First . take off your panel that covers the fuse panel by your knees. put your head up under the dash and look for the shift linkage. some times the screws that hold the plate on where the ...
Usually answered in minutes!
448 Questions
438 Questions
414 Questions
360 Questions
311 Questions