oil pressure sending unit. The light should go out when the wire is unplugged, and if it does it is bad. That's your continuity test. If you unplug the oil pressure sending unit and the light does not
...wire it is an oil pressure sending unit. if it has a plug with 2 or more wires it is an oil pressure switch and sends a signal to the inboard computer. Remove the wire either a nut or usually a ...
...oil pressure light, touching the wire to ground and then removing the wire from ground should turn the light on and off. If either happens, the gauge and wiring are good and the sending unit is at ...
...wire between the oil pressure switch sense circuit and ground. If the warning lamp lights, replace the oil pressure switch. If the warning lamp doesn?t light, keep the jumper wire connected and ...
...wire around the engine and oil pressure sending unit switch. If the wire at the connector checks out OK, pull the connector loose from the switch and, with a jumper wire, ground the connector to the ...
...oil pressure sending unit is located? It may be on top of engine at the back? In the diagram, the top wire should be ref voltage, key on, bottom wire should be a ground. If you don't want to do ...
Question about Guardian Generator Oil Pressure Switch 0d9235b
...does not show any oil pressure after replacing plugs an d wires You probably knocked a wire loose for the oil pressure guage when you were changing the plugs. Check all connection and it should
Question about Guardian Generator Oil Pressure Switch 0d9235b
pressure switch socket. Connect the electrical wire to the new oil pressure switch. Start the vehicle and check for oil leaks at the oil pressure switch. Verify the operation of the oil pressure gauge
Question about Guardian Generator Oil Pressure Switch 0d9235b
...wire around the engine and oil pressure sending unit switch. If the wire at the connector checks out OK, pull the connector loose from the switch and, with a jumper wire, ground the connector to the ...
Question about Guardian Generator Oil Pressure Switch 0d9235b
...oil pressure switch will have a wire leading from the electrical connector to the switch itself. Once you have located the oil pressure switch, you can replace it if it is faulty or damaged. It is ...
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions
