switch that mounted under dash to the top of the brake pedal that controls locking mechanism on shift. Its a safety feature, for example if the car was running and a kid gets in the driver seat he/she
...the only thing i have noticed is the indactor for the shift lever is off 1 thur 4 and is dead on in nuetral reverse and park any ideas please help The elec. shift switch the transmission mite be
...switch on the top of the brake pedal lever. Cross the two wires in the connector with a paper clip - if the brake lights now work, your switch is probably bad. check fuses both in both comparments. ...
brake lights on If the brake lights are staying on this is most commonly caused by a stuck or misadjusted brake light switch. It is normally located on the upper part of the brake pedal lever.
...lever. NOTE: The door disarm switch can be installed in more than one position. Before removing the switch from the cylinder it may be necessary to mark the position of the switch in relation to the ...
...switch/lever broken.I have removed the column covers,must now remove ignition switch,except the lever/pin that has to be poked thru the pinhole was broken by someone previously.Now cannot remove the ...
...lever aligns with the switch body flange [12 mm (0.472 in.) wide portion]. 5. Tighten the attaching bolts (2 pcs.) to the specified torque. When setting up the switch body, be careful O-ring does not ...
...pedal lever. This switch often gets knocked out of position by the drivers feet. Or the switch can also be broken. The signal from this switch will release the gearshift. Please comment on my
...lever switch is either broken or knocked out of position. Happens often with Drivers feet kicking the switch. Go under dash and inspect brake lever for switch. This is a planned thing to insure your ...
brake lights dont work 1998 sable Check the switch on the brake pedal lever. The drivers feet can bump this out of position.
Usually answered in minutes!
689 Questions
627 Questions
646 Questions
540 Questions
534 Questions
